log_level=4
locale="en-US"
timezone="America/New_York"
/* NET to use for h/w tests */
test_net=1
bit_xcvr=0
bit_preset=5
bit_frequency=166800000
brd_overtemp=65
Siren_Type=1
Siren_Length=600
alarms_in {
  /* Cabinet doors open (a.k.a. tamper) switch */
  Tamper=1
  /* Water or other liquid sensor */
  Waterleak=1
  /* Primary power source failure */
  AC_Fail=1
  /* Backup battery failure */
  Battery=1
  /* Battery charger failure */
  Charger=1
  /* Riser disconnect or high VSWR */
  High_VSWR=2
  /* Low TX power */
  Low_TXPWR=2
  /* Overtemperature */
  Overheat=2
}
NET1 {
  receiver {
    /* default repeater channel name, reserved for future use */
    name="FDNY_CH.11"
    /* Transceiver to use for default channel RX */
    xcvr=0
    /* Above transceiver preset to use for default channel RX */
    preset=0
    /* Default channel RX frequency, reserved for future use */
    frequency=486012500
    /* Bypass receiver analog processing entirely */
    apmr_bypass=false
    /* Invert analog audio from transceiver (will invert DCS code) */
    apmr_invert=false
    /* Analog audio input gain */
    apmr_inpgain=1
    /* true for 12.5 kHz channel spacing, false for 25 kHz */
    narrow=false
    /* keep false unless you are sure that the other side uses it */
    companding=false
    /* Usually true for analog FM audio, the TX side uses pre-emphasis */
    de-emphasis=false
    /* Squelch/sub-audible signaling type: CSQ, CTCSS or CDCSS */
    squelch_sys=2
    /* PL tone or DCS code number, set to 0 if you want to disable sub-audible detection */
    squelch_code=28
    /* P25 support: 0 - none, 1 - FDNY/MOTOROLA TPSK, 2 - Phase 1 */
    p25_type=1
    /* invert P25 (digital) input */
    p25_invert=true
    p25_inpgain=1
  }
  transmitter {
    /* default repeater channel name, reserved for future use */
    name="FDNY CH.11"
    /* Transceiver to use for default channel TX */
    xcvr=2
    /* Above transceiver preset to use for default channel TX */
    preset=2
    /* Default channel RX frequency, reserved for future use */
    frequency=483012500
    /* Bypass transmitter analog processing entirely */
    apmr_bypass=false
    /* Invert analog audio to transceiver (will invert DCS code) */
    apmr_invert=false
    /* true for 12.5 kHz channel spacing, false for 25 kHz (affects CTCSS CML LPF) */
    narrow=false
    /* keep false unless you are sure that the other side uses it (affects CTCSS CML) */
    companding=false
    /* keep false unless you are sure that the other side uses de-emphasis (affects CTCSS CML) */
    pre-emphasis=false
    voice_level=120
    /* sub-audible signalling type: CTCSS or DCS, currently only CTCSS (a.k.a. PL) supported */
    squelch_sys=2
    /* PL tone or DCS code number (Table 5 or 7 in CML datasheet), set to 0 if you want to use CML (for HPF, limiting, etc.), but don't want to generate PL tone */
    squelch_code=28
    squelch_level=90
    /* P25 support: 0 - none, 1 - FDNY/MOTOROLA TPSK, 2 - Phase 1 */
    p25_type=1
    /* invert phase of the audio to transmitter */
    p25_invert=false
    p25_level=300
    p25_offset=90
    ramp-up=100
    tx_pwrlow=100
  }
  console {
    ip_address="10.0.0.11"
    pttid=6220011
    pttid_pre=true
    pttid_post=true
  }
}
NET2 {
  receiver {
    /* reserved for future use, currently unused */
    name="FDNY CH.12"
    xcvr=1
    preset=1
    /* reserved for future use, currently unused */
    frequency=487762500
    apmr_bypass=false
    apmr_invert=true
    apmr_inpgain=1
    /* true for 12.5 kHz channel, false for 25 kHz (affects CTCSS CML LPF) */
    narrow=false
    /* keep false unless you are sure that the other side uses it (affects CTCSS CML) */
    companding=false
    /* keep false unless you are sure that the other side uses pre-emphasis (affects CTCSS CML) */
    de-emphasis=false
    /* sub-audible signalling type: CTCSS or DCS, currently only CTCSS (a.k.a. PL) supported */
    squelch_sys=2
    /* PL tone or DCS code number (Table 5 or 7 in CML datasheet), set to 0 if you want to use CML (for HPF, limiting, etc.), but don't want specific PL detection */
    squelch_code=28
    /* P25 support: 0 - none, 1 - FDNY/MOTOROLA TPSK, 2 - Phase 1 */
    p25_type=1
    p25_invert=true
    p25_inpgain=1
  }
  transmitter {
    /* reserved for future use, currently unused */
    name="FDNY CH.12"
    xcvr=3
    preset=3
    /* reserved for future use, currently unused */
    frequency=484762500
    apmr_bypass=false
    apmr_invert=false
    /* true for 12.5 kHz channel, false for 25 kHz (affects CTCSS CML LPF) */
    narrow=false
    /* keep false unless you are sure that the other side uses it (affects CTCSS CML) */
    companding=true
    /* keep false unless you are sure that the other side uses de-emphasis (affects CTCSS CML) */
    pre-emphasis=false
    voice_level=600
    /* sub-audible signalling type: CTCSS or DCS, currently only CTCSS (a.k.a. PL) supported */
    squelch_sys=2
    /* PL tone or DCS code number (Table 5 or 7 in CML datasheet), set to 0 if you want to use CML (for HPF, limiting, etc.), but don't want to generate PL tone */
    squelch_code=28
    squelch_level=500
    /* P25 support: 0 - none, 1 - FDNY/MOTOROLA TPSK, 2 - Phase 1 */
    p25_type=1
    /* invert phase of the audio to transmitter */
    p25_invert=false
    p25_level=53632
    p25_offset=90
    ramp-up=100
    tx_pwrlow=100
  }
  console {
    ip_address="10.0.0.12"
    pttid=6220012
    pttid_pre=true
    pttid_post=true
  }
}